Bwana Kungu,
I have not yet managed to setup the Humax am still using my old Astrovox. I was thinking maybe it had to connect to the four preprogrammed satellites for it to become fully activated. Currently even network functions are not working. Do you have any experience with the Humax decoders?
Good Evening Kaminja,
I am using Humax 2020 hd which also has the Humax portal
The interface is most likely the same.
To set up the receiver, first select installation tab on your menu via remote>>>
Select the satellite table you want to set>>>
On the satellite setting tab select the name of the satellite you want to set.
Select the DiSEqC port if using switch.
If not set DiSEqC at port 1
Use Test Transponder tab to select the transponder you want to test satellite signal on.
You can install the frequency of your like via
User Define tab
Check polarity depending on LNB installation.
Before scanning the frequencies on a desired satellite, set the other satellite table ( Badr, Hotbird etc) as
Transponder None>>>
Now you can search Nilesat table to see what frequnies come uo.
To access the Humax Portal you need to connect your receiver to the internet via Ethernet port or Wifi.
I access my Internet i use Ethernet cable connected to receiver.
I use a Portable 3G wireless N Router called TP LInk Mr 3020[h=1][/h]
Once connected to receiver, select System tab>>>
Internet settings>>>
Configure LAN>>>>
Configure IP>>>
Apply and select DHCP to automatically set router link address>>>
Once completed, you should be able to access the Humax portal>>>
Happy Hunting